Garage Door Track Replacement

Track replacement fits new vertical and horizontal tracks when the existing set is creased, torn at a bracket hole, rusted through, or simply the wrong track for the door; a heavier insulated door hung in light-gauge track, for example, will flex and spread it. Unlike a repair, which works the existing steel back into line, replacement starts from bare jambs: the door is taken down or fully secured, the rollers come out with it, and the old tracks and brackets are stripped so nothing of the old alignment carries over by accident. The new track is matched to the door in three respects: the channel size for the rollers the door carries, the gauge for the door's weight, and the curve radius for the headroom above the opening. Standard-lift track uses a twelve- or fifteen-inch radius curve; low-headroom doors use a dual-track arrangement that turns the door in less space, and those geometries are not interchangeable. Vertical tracks go up first, plumbed and set so the door will close tight against the frame with the rollers held in light, even contact. Horizontal tracks are leveled, hung from the ceiling framing with punched angle at the rear, and set so the door rises slightly away from the frame as it opens, which keeps the sections from rubbing the jamb. Flag brackets tie the curve to the spring shaft hardware, so the spring line is checked as part of the same job and the shaft's bearing plates are confirmed solid in the framing. With the door rehung, every roller is watched through the curve, clearances are compared on both sides, and the opener is reconnected only after the door runs true by hand. The finished set should show no scrape marks, no point where the door hesitates, and an even seal line around the closed door.

Free EstimateCall (888) 248-0203