Garage Door Opener Replacement

Opener replacement is the right call when the existing unit is at the end of its working life: a logic board that has failed more than once, a cracked or heat-warped housing, drive parts that are no longer made, or an older unit built before photo-eye safety sensors became standard equipment, which no repair can bring up to current safety practice. The door is tested by hand first, as with any opener work, and spring or track faults are corrected so the new unit starts its life moving a balanced door. The old opener, rail, and wiring come down, and the header bracket and ceiling mount are inspected; the new unit often lands on the same mounting points, but brackets that were lagged into trim or drywall rather than framing are re-anchored properly. The replacement is selected by drive type against the household's priorities: a belt drive where bedrooms sit over the garage and quiet matters, a chain drive where simplicity and hard use lead, or a wall-mounted jackshaft where ceiling clearance is needed. The rail is assembled, hung level, and connected to the door with the correct arm geometry, and new safety sensors are fitted at the base of the opening and aligned, since reusing old sensors with a new head unit invites nuisance reversals. All remotes and the keypad are programmed fresh to the new unit, which also means codes from the old unit, including any remote that was lost or kept by a previous occupant, no longer open the door. Travel limits and closing force are set to the door, and the installation finishes with the contact-reversal test on a block at floor level and the sensor-beam reversal test, both repeated until the door responds correctly every time. The old unit and its hardware are taken away rather than left in a corner of the garage.

Free EstimateCall (888) 248-0203