Garage Door Opener Repair
Opener repair begins with separating opener faults from door faults, because the two imitate each other. The door is disconnected with the release cord and moved by hand: a door that is heavy or binding points at springs and hardware, while a door that glides easily points at the motor unit. An opener that hums but does not move has often stripped its drive gear; on many units a nylon gear inside the housing wears until its teeth are powder in the bottom of the case. A failed start capacitor gives the same symptom, and both are replaceable parts. An opener that runs while the door stays still has usually broken its belt or chain, stripped the trolley that the door arm connects to, or snapped the sprocket at the top of the unit. A unit that starts, travels a short distance, and reverses is commonly reading its force setting against a door that has grown heavier, or its travel limits have drifted. The cause is corrected before the force is touched, since raising force to overpower a heavy door defeats the safety system. A door that reverses near the floor with nothing under it is frequently tripped by safety sensors that are misaligned, struck by direct sun, or working with a nicked wire that shorts where it is stapled along the track. Remote problems, meaning short range, working only up close, or a door that operates on its own, trace to weak remote batteries, a failing receiver on the logic board, radio interference from LED bulbs fitted in the opener itself, or a stuck wall button. Logic boards damaged by power surges are replaced as a unit, and the new board is programmed to the existing remotes and keypad. Every opener repair ends with the two safety tests: reversal on contact with an obstruction at floor level, and reversal when the sensor beam is broken.
