Garage Door Opener Installation
Installing a new opener starts with the door, not the motor. An opener is built to move a door that is already balanced by its springs, so the door is disconnected and lifted by hand first; a door that is heavy, crooked, or binding gets its spring or track problem corrected before any motor is hung, because a new opener fitted to a bad door wears out doing the springs' work. The opener itself is chosen by drive type and by the door it will run. Chain drives are durable and simple, belt drives run noticeably quieter, which matters with living space above the garage, screw drives have few moving parts, and wall-mounted jackshaft units turn the spring shaft directly and clear the ceiling where storage or a vehicle lift needs the room. Horsepower ratings matter less than the door's balance and the unit's rating for the door's weight class. The rail is assembled and set so it sits level from the header bracket above the door to the motor head, the header bracket is anchored into the header framing and never into drywall or trim alone, and the door arm is connected with the door closed so the geometry pulls the door up its tracks rather than into them. Safety sensors are mounted near the floor on both sides of the opening, aligned until their indicator lights confirm they see each other, and wired back to the motor. The wall control, remotes, and any keypad are programmed, then the travel limits and force settings are dialed in and tested: the door must reverse off a block placed flat on the floor under it, and the sensors must reverse it when the beam is broken while it closes. Those two reversal tests are the point of the installation, and they are repeated until both pass cleanly.
