Garage Door Off-Track Repair
A door comes off its track when one or more rollers leave the channel they ride in, and it usually happens for a reason: a cable breaks and drops one side, the door is run into an obstruction, a vehicle clips a section, or a worn roller with a collapsed bearing walks out of a track that has spread or bent. The door typically stops crooked, jammed at an angle with a gap at one side and the sections under stress. The first rule with an off-track door is not to force it, and not to keep pressing the opener button. An opener can fold a jammed section, pull track brackets off the wall, and turn a reseat job into a panel and track job. The door is disconnected from the opener and secured where it sits, clamped or blocked, because a door hanging on a few rollers can drop without warning. Repair starts with finding what pushed the rollers out. Cables and springs are checked first, since a door that lost a cable will come off the track again the moment it is reseated if the cable is not dealt with. The track is inspected along the affected side for bends, crushed sections, and loose or pulled-out brackets. Rollers are reseated by opening the track at a joint or by removing the roller from its hinge, depending on where the roller sits, and a roller that left the track because its stem or bearing failed is replaced rather than put back. Bent track is straightened where the steel has only deflected, and replaced where it is creased or torn. With every roller back in its channel, the door is moved slowly by hand through its full travel, each roller is watched through the curve, and only then is the opener reconnected and its travel limits and force checked.
