Garage Door Cable Replacement
Cable replacement fits a new set of lift cables when the old ones are frayed, rusted, kinked, or stretched past the point where the door can be leveled. The cables on a residential door are stranded steel aircraft cable, most often 1/8 inch in diameter for standard doors and heavier for wide or insulated doors, and their length is matched to the door height and drum size so the cable fills the drum grooves without overlapping when the door is closed. The work begins with the door fully down and clamped, and the spring tension is released in a controlled manner before any cable is detached, because a cable removed under load can whip and the door can drop. The old cables come off the bottom brackets and drums, and the drums, bottom brackets, and the lower edges of the bottom section are inspected while access is open, since a drum with worn grooves or a bracket rusted through will shorten the life of a new cable. New cables are fitted to both sides in the same visit even if only one has visibly failed, because the pair has carried the same cycles and the surviving cable is usually not far behind. With the cables seated, spring tension is wound back on, the drums are set so both cables take up slack at the same moment, and the door is leveled so its bottom seal meets the floor evenly along its full width. On extension-spring doors the safety cables that run through the springs are checked or refitted at the same time; they are what contain a spring if it breaks. The door is then run through several full cycles by hand and under the opener to confirm the cables track onto the drums cleanly, without rubbing the track or stacking on one side of the drum.
