Emergency Garage Door Repair

A garage door that fails without warning usually fails at the worst point in its travel: stuck halfway open, jammed crooked in the frame, or down with a vehicle trapped inside. Urgent repair work starts with making the door safe to be around. A sectional door that has come off its track or lost a cable can weigh well over a hundred pounds with nothing holding it, so the first step is to secure the door in place with locking pliers clamped on the track, or with the door fully lowered and supported, before anyone walks under it. The opener is unplugged so it cannot be triggered while hands are near the moving parts. Once the door is stable, the failure is traced to its cause. A snapped torsion spring leaves the door dead-heavy, with the opener straining or refusing to lift. A broken cable lets one side drop and racks the door sideways in the opening. A vehicle that has backed into a panel can bend the section, pull rollers out of the track, and twist the track itself. Each of these is diagnosed by inspection rather than by running the door, because cycling a damaged door under power makes bent parts worse. Where the failed part is on hand, the repair is completed and the door is put through a full balance and travel test before the opener is reconnected. Where a section or a matched spring has to be ordered, the door is left secured: closed and locked where possible, or braced with the opener disabled where it is not, so the opening is not left unguarded. The visit also covers the parts that did not fail. Hinges, rollers, and the second cable are checked, because the part that broke is often not the only one near the end of its life. A door that has been forced, frozen to the threshold seal, or struck by a vehicle should not be run on the opener until it has been looked at; the opener's force is enough to fold a weakened section or pull a loose track off the wall.

Free EstimateCall (888) 248-0203